Free Pass4sure Avaya ACIS 6102 Dumps

 

Avaya Virtual Services Platform 9000 Implementation Exam: 6102 Exam

6102 Questions & Answers

Exam Code: 6102

Exam Name: Avaya Virtual Services Pla

tform 9000 Implementation Exam

Q & A: 72 Q&As

QUESTION 1
A support engineer will use the EDM web-based embedded element management tool to support the Virtual Services Platform (VSP) 9000 configuration management.
Which ACLI configuration is mandatory to allow the users to login into EDM via a web browser for the first time?
A.    Enable the web server and configure a webserver admin password.
B.    Only enable the web-server.
C.    Only configure the web-server admin password.
D.    The web server is enabled by default with a default password.
Answer: B

QUESTION 2
A customer has a stack of Ethernet Routing Switch (ERS) 5698TFD switches, the uplinks to the network core are via two Gigabit uplink ports from the first ERS 5698TFD in the stack to a single virtual services platform (VSP) 9000. The links are not part of a Multi-Link Trunk (MLT) and spanning tree is running.
This results in one of the links always being blocked and recovery time unacceptably long when the active uplink fails. They need to have both links active to increase the bandwidth to the core, and at the same time provide better redundancy.
What is the preferred Avaya solution for the customer?
A.    Move only of the uplink to another ERS 5698TFD in the stack and disable spanning-tree on both uplinks.
B.    Move one of the uplinks to another ERS 5698TFD in the stack and enable Equal Cost Multi- Path (ECMP)
on the uplinks.
C.    Move one of the uplinks to another ERS 5698TFD in the stack, configure MLT, and group the two uplinks
in a distributed Multi-Link Trunk (DMLT)
D.    Move one of the uplinks to another ERS 5698TFD in the stack, and ensure that the uplinks terminate on
different modules in the VSP 9000.
Answer: C

QUESTION 3
Which statement about the local router MAC addresses on RSMLT aggregation switches (cluster) is true?
A.    On a RSMLT aggregation switch pair, local router MAC addresses are exchanged, and only used in
case of switch failure.
B.    On a RSMLT aggregation switch pair, local router MAC addresses are exchanged, and used for data
forwarding.
C.    On a RSMLT aggregation switch pair, local virtual MAC addresses is exchanged, and used for data
forwarding.
D.    RSMLT aggregation switches are not exchanging local router MAC addresses, but are using the IP
destination address to forward traffic.
Answer: B

QUESTION 4
A customer is concerned about the security of their network. They need to understand the OSPF authentication options when accepting route updates in OSPF. Currently, their Virtual Service Platform (VSP) 9000 is configured to require no authentication when receiving the OSPF updates.
Which two supported authentication types would provide security on the VSP 9000 for OSPF updates? (Choose two.)
A.    MD5
B.    3DES
C.    RADIUS
D.    Simple Password
Answer: AD

QUESTION 5
The following ACLI commands are used to set up an MLT on the Virtual Services platform (VSP) 9000 and the last command in this sequence produces an ACLI error.
VSP-9012:1 (config) # mlt 1
VSP-9012:1 (config) # mlt 1 name IST
VSP-9012:1 (config) # mlt 1 member 3/1, 3/2
VSP-9012:1 (config) # mlt 1 vlan 2, 10, 11, 12
What should be done to correct the problem?
A.    Set up the IST on the other VSP 9000 before adding the VLANs.
B.    Add port members 3/1, 3/2 to each of the VLANs before adding them to the MLT.
C.    Specify that the MLT is using encapsulation dot1q.
D.    Assign the IST peer-ip before adding the VLANs.
Answer: A

QUESTION 6
The Chassis Area Network (CAN) uses the SERDES to connect which modules in the Virtual Services Platform (VSP) 9000?
A.    Switch Fabric cards and I/O cards
B.    CP curds and Switch Fabric cards
C.    CP cards and Switch Fabrics in slots 1 & 4
D.    All 10 I/O cards, six SF cards and two CP cards
E.    CP cards and all I/O cards
Answer: A

http://www.lead2pass.com/6102.html

Why Choose Lead2pass?